Table of Contents
Advertisement
Module".
3. Disconnect the connector to the Z2-P.C.Board.
4. Unscrew the 2 screws fixing the connector to the lamp unit.
5. Unscrew the 1 screw fixing the ground lug.
6. Unscrew the 1 screw (optical block side) fixing the ground fitting.
7. Unscrew the 3 screws fixing the power unit.
8. Take the power unit out and disconnect the connectors.
5.8. Removal of Analysis/LCD Blocks
1. Remove the upper cover according to the section 5.2. "Removal of
Upper Cover".
2. Remove the A-Module according to the section 5.3. "Removal of A-
Module".
3. Remove the Z3-P.C.Board according to the section 5.4. "Removal
of Z3-P.C.Board".
4. Remove the power unit according to the section 5.7. "Removal of
Power Unit".
5. Unscrew the 1 screw and remove the thermofuse.
MC-Service
12
Advertisement
Table of Contents
