Table of Contents
Advertisement
patterns with the green one.
6.4.3. Adjustment after LCD Panel (G) Replacement
1. Connect a PC to the RGB connector and display the white
crosshatch pattern (service pattern data is required), then adjust
the lens focus.
2. Adjust the LCD panel (G) to merge the green pattern with the red
and blue ones.
6.4.4. Adjustment after LCD Panel (R) Replacement
1. Connect a PC to the RGB connector and display the white
crosshatch pattern (service pattern data is required), then adjust
the lens focus.
2. Adjust the LCD panel (R) to merge the red pattern with the green
and blue ones.
6.4.5. Adjustment after LCD Panel (B) Replacement
1. Connect a PC to the RGB connector and display the white
crosshatch pattern (service pattern data is required), then adjust
the lens focus.
2. Adjust the LCD panel (B) to merge the blue pattern with the green
and red ones.
6.5. Software for Adjustment
6.5.1. Outline
1. This projector needs computer-aided adjustments.
2. After the software adjustments, this projector must be turned off
and on again to memorize the settings.
3. Connect the cable between the projector and a PC as shown below.
4. Updating the software will change the version number.
19
Advertisement
Table of Contents
