Important Assembly Information; Technical Specifications; Fireplace Insert - Supra NEO 67 G Manual

Foyer insert

Table of Contents

Available languages

You have just purchased an appliance from our range. We would like to congratulate you on your choice. This appliance has been

carefully designed. In order to get the very best out of it, we would advise you to request the services of one of our specialists. This will

ensure that the installation is done in accordance with good practices and will guarantee the best operating and safety conditions,

bearing all the responsibility for the final installation.

Before lighting the fire for the first time, carefully read through these installation instructions and user manual. Keep the manual and

warranty safe (as this indicates the model and serial Nº). The person performing the installation work shall be fully liable for any failure

to comply with the instructions set out in these two documents.

Your chimney «draws well», but you are unsure of the draught value. The chimney draught is measured in Pascal (Pa). The

inserts, fireboxes and stoves have been designed, optimised and manufactured in accordance with standards NF EN 13229

(or NF EN 13240) to operate connected to a chimney with a draught of 12 Pa. It frequently happens (in more than one in two

chimneys) that the draught is far too high (over 20 Pa) due to the fact that the chimney is either too high or due to the flue

liner. In this case, the appliances will operate in abnormal conditions which may lead to:

- Excessive wood consumption: this can be three times as much as an appliance with a draught of 12 Pa.

- A fire that "keeps going out" and burns too quickly while producing insufficient heat.

- A quick and inevitable deterioration of the appliance (cracks in the cast iron panels or in the refractory bricks)

- A voided warranty.

To avoid all these problems, there is only one solution!

Get a professional to check the chimney draught (with the appliance operating) and, if it is above 20 Pa, then install a damper

or an adaptor at the flue connection.

1. TECHNICAL SPECIFICATIONS

FIREPLACE INSERT

Stove category

Rated heat output (1)

Operating mode

Average flue gas temperature with the door closed

Efficiency

Seasonal efficiency

CO concentration (13% 02)

CO2 concentration (13% 02)

Dust concentration (13% 02)

VOC

NOX

Fuel

Log size

Nominal load per hour approx.

Refuelling

Prohibited fuels

Approx. flue gas mass flow

Flue pipe nominal diameter

Characteristics of the flue pipe

Chimney flue minimum dimensions

Ø min. flue lining or insulated metal duct

Minimum height above the hearth

Diameter of combustion air collar

Ventilation of the room

Draught (10 Pa = 1 mm CE)

Nominal efficiency

Performance in slumber mode (min. permitted)

Max. permitted

Net/gross weight

Nameplate

Air connection collar

Accessories supplied

Cold hand key, heat-insulated glove, frame's bottom cross member, combustion air connection collars ø 75.

Option available

Turbine kit 220-240 V - 50 Hz

Hot air distribution collars (Ø125 or Ø150) (only for

hearth installation)

Beam protection kit

Feet

(1) Nominal operating power with door closed, wood fuel; according to tests carried out as per EN 13229 standard.

(2) DTU 24.1 covering flue ducting, DTU 24.2 covering chimneys equipped with a closed stove; NF EN13229 covering solid fuel stoves.

(Available at AFNOR).

- IMPORTANT -