Safety Alerts - Hover-1 AXLE Operation Manual

SAFETY ALERTS

While riding your Axle, if there is a system error or improper operation
performed, the Axle will prompt the user in a variety
of ways.
You will notice the Running Indicator Light will turn RED and you will
hear a beep sound alerting you to take precaution and cease
operation, which may make the device stop suddenly.
The following are common occurrences where you will hear the
Safety Alerts. These notices should not be ignored, but appropriate
action should be taken to correct any illegal operation, failure or
errors.
• Unsafe riding surfaces (uneven, too steep, unsafe, etc.)
• When you step on the Axle, if the platform is tilted more than 10
degrees forward or backward.
• Battery voltage is too low.
• The Axle is still charging.
• During operation, the platform self initiates to tilt due to excess
speed.
• Overheating, or motor temperature is too high.
• The Axle has been rocking back and forth for over 30 seconds.
• If the system enters protection mode, the alarm indicator will light
up and the board will vibrate. This typically occurs when the battery
is about to run out of power.
• If the platform is tilted forward or backward more than 10 degrees,
your Axle will power off and stop suddenly, possibly causing the rider
to lose balance or fall off.
• If any or both tires are blocked, the Axle will stop after 2
seconds.
• When the battery level has depleted below protection mode, the
Axle engine will power off and stop after 15 seconds.
16