Table of Contents
Advertisement
• While sustaining a high discharge current during use (such as
driving up a steep slope for a long period of time), the Axle engine
will power off and stop after 15 seconds.
CHARGING YOUR AXLE
CHARGING THE AXLE
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris or dirt inside the port.
• Plug the charger into a grounded wall outlet. The charging
indicator light ON THE CHARGER will be green.
• Connect the cable with the power supply (100V ~ 240V; 50/60 Hz).
• Align and connect the 3-pin charging cable into the charging
port of the Axle. DO NOT FORCE THE CHARGER INTO THE CHARGE
PORT, AS THIS MAY CAUSE THE PRONGS TO BREAK OFF OR
PERMANENT DAMAGE TO THE CHARGE PORT.
• Once attached to the board, the charging indicator light ON THE
CHARGER should change to RED, indicating that your device is now
being charged.
• When the RED indicator light on your charger turns to GREEN, then
your Axle is fully charged.
• A full charge may take up to 5 hours. While charging, you will see
a yellow flashing light on the scooter, which also indicates charging.
Do not charge for more than 7.5 hours.
•After fully charging your Axle, unplug the charger from your Axle
and from the power outlet.
WARNING
When the Axle turns off during a Safety
Alert, all operation systems will halt. Do
not continue attempting to ride the
Axle when the system initiates a stop.
Turn your Axle off and back on to unlock
it from a Safety Lock.
17
Advertisement
Table of Contents
