Installation Requirements - Ubiquiti airFiber X AF-11G35 Quick Start Manual

https://arttel.ru/
Antenna Compatibility
The airFiber AF-11G35 antenna is designed for use with the
DLU)LEHU ;©UDGLR©PRGHO©$)õ

Installation Requirements

• 13 mm wrench (pre-assembly tool)
• 17 mm wrench (pole-mounting tool)
• DLU)LEHU©$)õ
installed
• Clear line of sight between airFiber radios
• Vertical mounting orientation
• Mounting point:
• At least 1 m below the highest point on the structure
• For tower installations, at least 3 m below the top of
WKH WRZHU
• Ground wires – min. 10 AWG (5 mm
$V D©VDIHW\©SUHFDXWLRQ ©JURXQG©WKH©DLU)LEHU©UDGLRV©WR©
grounded masts, poles, towers, or grounding bars.
WARNING:
airFiber radio will void your warranty.
• (Recommended) 2 Outdoor Gigabit PoE surge protectors
Note:
protection, follow your local electrical regulatory codes.
• (Optional) If not using PoE: DC power source and 12/30 AWG
power cable.
• Outdoor, shielded Category 6 (or above) cabling and
shielded RJ-45 connectors are required for all wired Ethernet
connections.
* Check your local/regional regulations for the allowable antenna gain
allowed for your application.
https://arttel.ru/shop/antenny/ubiquiti-airfib
);
);©UDGLR© VROG©VHSDUDWHO\ ©ZLWK©GXSOH[HU V ©
Failure to properly ground your
For guidelines about grounding and lightning
* .
2
©DQG©PD[ ©OHQJWK P ©