Table of Contents
Advertisement
USING
THE
AC
Start your REDBACK Generator as per the instructions
the
'STARTING YOUR GENERATOR' section.
Let
your
REDBACK Generator
display y shows 240v, your REDBACK Generator
Ensure
your
equipment is turned
USING
THE
DC
WARNING! The DC outlet is for charging 12v batteries only, note that the battery
charging outlets IS NOT regulated. You must monitor the battery voltage. If the
voltage exceeds 14v you must immediately disconnect the battery. Failure to do
so can result in overcharge and may cause fire or explosion.
Connect the alligator clips first and then insert the 'T' plug into your REDBACK
Inventor Generator.
If charging a car battery, ensure the battery is disconnected from your car. DO
NOT starts your car while the charging cable is connected. Doing so will damage
your REDBACK Inventor Generator.
DO NOT cross the polarity of the cables, doing so can damage your REDBACK
Inventor Generator.
Ensure battery charging is done in a dry, safe, ventilated are away from the
hazards or flammable liquids and / or gases.
In the unlikely event battery acid comes in contact with skin or eyes immediately
go to hospital and see a doctor.
When using AC, DC can be used simultaneously.
A
DC surge may
cause
press the DC Protection button located
All manuals and user guides at all-guides.com
POWER
run
for
off
before connecting to the
POWER
the DC protection switch
a
short
while. Once
is
ready to be used.
to
depress. If this happens,
on
the
Control Panel.
in
the
digital
AC
outlets.
15
Hide quick links:
Advertisement
Table of Contents
