Table of Contents
Advertisement
2
2
3
2-24
Printing from the Multi-Purpose Tray
Spread the paper guides a little wider than the actual
transparency width.
Fan the transparencies in small portions and align the edges.
Fan a few amount at a time.
CAUTION
Be careful not to cut your hands with the edges of the transparencies.
IMPORTANT
•
When fanning or aligning the transparencies, try to hold the edge of paper as much
as possible to avoid touching the printing side.
•
Be sure to fan the transparencies thoroughly before loading them. Not fanning
them properly may result in the transparencies to overlap, causing paper jams.
•
Take care not to mark or stain the printing side of the transparencies with
fingerprints, dust, or oil. This may result in poor print quality.
Align the edge by tapping
the stack on a flat surface.
Advertisement
Table of Contents
