Range Test - Tunstall Vi+ Quick Start Manual

Programming the Vi+ using a Series Telephone
Programming a telecare sensor to the Vi+
Telecare sensors with plug and play functionality can be programmed to the Vi+
using the following steps:
Step 1 – Press and hold down the green
cancel button until it bleeps (approx. 5
seconds). The Vi+ announces
'Programming mode' and the red alarm
button flashes slowly.
Step 2 – Press and hold down the green cancel button again until it bleeps
(approx. 3 seconds). Release the cancel button, the Vi+ announces 'Registration
Mode' and the red alarm button flashes rapidly.
Step 3 – Activate the sensor/trigger, the Vi+ will announce the trigger type to
confirm registration.
Step 4 – Press and release the green cancel button. The Vi+ will bleep
(programming mode exited).
Step 5 – Test the sensor/trigger by activating it and ensuring it raises an alarm
call.
If you would like to know which telecare sensors are currently available, please
contact your supplier.

Range Test

The Vi+ has a range test feature that enables you to test the range of personal
triggers without raising an alarm call. This is done by putting the Vi+ into
programming mode (press and hold down the green cancel button until it bleeps).
When in programming mode, press the required personal trigger if it is within range
the Vi+ will bleep and announce the trigger or telecare sensor type.
Page 3 Ver 1 4/24/2015