Advertisement
Setting the time and date
There is a real time 24 hour clock in the Vi+ which automatically adjusts for daylight savings
time. During power outages the clock is backed up by the Vi+'s battery for up to 40 hours.
However if the unit is powered down for transit then the clock must be reset again when the
Vi+ is installed in the user's home. Once the time has been set the time can be checked by
using the quick code 3020. The unit will then announce the date and time. During the first
30 minutes of installation the Tunstall Vi+ will also announce the date and time when an
incoming telephone call is received (requires CLI on the telephone line). To set the clock
press:
DD represents the day of the month (01-31) MM
represents the months (01-12)
YY represents the two digit year (00-99)
HH represents hours 00-23; 24 cannot be programmed MM
represents minutes 00-59; 60 cannot be programmed
X represents the daylight saving time zone (0 = disabled, 1 = Europe, 2 = US)
Y represents enable/disable auto CLI time update feature (0 = disable, 1 = enable)
Telephone numbers
The series telephone keypad supports the programming of 10 alarm numbers. By default,
telephone numbers 1-4 are set to call control centers (CC) and telephone numbers 5-10
are set to a Personal Recipient (PR) destination. To change the destination from CC to
PR or normal telephone (POTS) see the next section.
Control center numbers
Control center numbers are programmed by pressing:
Sets telephone number 1
To set tel. number 2 replace 00 with 01
To set tel. number 3 replace 00 with 07
To set tel. number 4 replace 00 with 08
To set tel. number 5 replace 00 with 09
To set tel. number 6 replace 00 with 10
NOTE: A pause can be entered when programming alarm numbers by pressing
the telephone number.
Page 5
Programming the Vi+ using a Series Telephone
DDMMYY HH MM X Y
Tel. No. (max 20 digits)
To set tel. number 7 replace 00 with 39
To set tel. number 8 replace 00 with 40
To set tel. number 9 replace 00 with 41
To set tel. number 10 replace 00 with 42
#2
as part of
Ver 1 4/24/2015
Advertisement
