Advertisement
OUT1
Output
÷
circuits
OUT12
Cascade control
Starting another cascade while the previous one is run-
ning will not interrupt the work of the first one, but will
start the next one in the set direction. The exception
here is the situation described in the next comment.
If during the cascade execution the last light is already
switched on and at the same time an input (DOWN or
UP) is triggered at the end of the cascade, the control-
ler will interpret such action as the first person leaving
the staircase and therefore will not trigger the cascade
of lights in the opposite direction.
Warning! It is possible to split the
power supply of the output circuits to
several power supply units.
In this case, you should:
» divide the output circuits into a
required number of groups and con-
nect the wires ("+") of the group to
the chosen power supply unit,
» connect the power supply of the con-
troller ("+" and "–") to one of the po-
wer supply units,
» the wires ("–") of all power supplies
should be connected with each other
and with the terminals ("–") of the
AS-225D controller.
- 10 -
Advertisement
