Restoring Factory Defaults - Hemisphere GPS S320 User Manual

Gnss survey receiver

Hide thumbs Also See for S320:

Manual (22 pages)

Table Of Contents

Table of Contents

Chapter 3: Setup and Configuration____________________________________________________________________

Displaying the Current List of Approved Numbers

To display the current list of approved numbers send the following command:

$JSMS,CONFIG

The reply below contains all the information on the configured numbers and may include SIM

card address book defaults that you can overwrite with your own information.

$>JSMS,CONFIG,1,1,+19995551212,Service,OFF

The format of the reply is:

$>JSMS,CONFIG,[number of approved numbers],[slot number 1/2/ 3],[number],[name],[status

messages ON | OFF]

Note: The reply contains one line for each number. For example, if there are two approved numbers

then the reply will contain a "$>JSMS,CONFIG" line for each number.

Deleting a Number from the Approved Numbers List

To delete a number from the approved numbers list, send the following command:

$JSMS,CONFIG,[1/2/3 or keyword ALL],DELETE

For example, to delete the number in slot 2 send the following command:

$JSMS,CONFIG,2,DELETE

And to delete all numbers from the list, send the following command:

$JSMS,CONFIG,ALL,DELETE

Sending an SMS Message to an Approved Number

To send an SMS message to an approved number, send the following command:

$JSMS,SEND,[name or phone number or slot number],[message]

For example, to send a "This is a test" message to Customer Support (USA phone number 480-348-

9919, slot number 2) you can send any of the following commands:

$JSMS,SEND,SERVICE,This is a test

$JSMS,SEND,+14803489919,This is a test

$JSMS,SEND,2,This is a test