Removing/Inserting The Sd Card / Sim Card - Hemisphere GPS S320 User Manual

Chapter 3: Setup and Configuration

Removing/Inserting the SD Card / SIM Card

Caution: Use electrostatic discharge (ESD) protection by wearing an ESD strap that is
attached to an earth ground, before inserting or removing the SIM card on the S320. If an
ESD strap is not available then touch a metal object prior to accessing the SIM card holder.
The SD card and the SIM card are only accessible by first removing the appropriate battery tray,
where the:
Left tray is labeled "SD"
Right tray is labeled "SIM"
To remove the SD card or SIM card:
1. Remove the appropriate battery tray.
2. Place the S320 upside down (on its top) to get a better view of the card.
Gently push the card in; it will then snap back and slightly out.
Note: When you insert either card make sure the contacts on the card are facing the top
of the unit and the side of the card with the notch goes in first (see figure in step 2 above).
3. Remove the card.
To insert the SD card or SIM card:
1. Place the card in its appropriate card slot.
2. Gently push the card in until it clicks.
3. Replace the battery tray.
S320 User Guide
notch end
goes in first
PN 875-0281-000 Rev C2