Alarm/Buzzer; Power And Battery Status/Charge - Hemisphere GPS S320 User Manual

Chapter 3: Setup and Configuration

Alarm/Buzzer

The S320 beeps under the following conditions:
Whenever you press a button
Position is lost
Differential position is achieved
Bluetooth device is connected/disconnected
Low memory for data storage (SD card almost full)
Both batteries are very low
If an alarm is sounding, you can silence the alarm by pressing the Power button.

Power and Battery Status/Charge

LEDs on the console provide power and battery status/charge information based on the color of the
LEDs. For example, Figure 3-2 indicates there is no external power, the right battery is fully charged,
and the left battery is not present (not in the unit).
Figure 3-2: No external power, right battery full, left battery not present
Table 3-5 describes what the power/battery LED colors indicate. The S320 prioritizes power usage to
use external power when available, regardless of the status of the internal batteries.
Table 3-5: Power/battery LED color descriptions
LED
Power
Left battery Right
battery
S320 User Guide
LED Color
Off
Red
Off
Red
Yellow
Green
Note: A blinking battery light indicates that battery is in use.
Meaning
No external power
External power present and in use
Battery not present
Battery very low or fully discharged (unit will beep
when both batteries are very low)
Battery less than 1/2 charged
Battery fully charged
PN 875-0281-000 Rev C2