T
roubleshooting
Vacuum cleaner won't turn on
Possible causes
1.
Power cord not plugged in
2.
Thermal protector activated
3.
Handle not fully attached
brush not rotating
Possible causes
1.
Brush switch turned to "OFF"
2.
Vacuum is in upright position
3.
Brush is jammed
4.
Brush needs to be reset
5.
Handle not fully attached
Vacuum cleaner won't pick up or low suction
Possible causes
1.
Incorrect height setting
2.
Hose wand not properly positioned
3.
Dirt container not installed properly
4.
Dirt container full
5.
Clog in cleaner
6.
Filters are dirty
7.
Hose not properly attached
16
w w w . b i s s e l l . c o m
WaRnInG:
to reduce the risk of electric
shock, turn power switch
off and disconnect plug
from electrical outlet before
performing maintenance or
troubleshooting.
Remedies
1. Check electrical plug
2. Allow cleaner to cool for 30 minutes, see
page. 13
3. Remove handle and reinstall
Remedies
1. Make sure brush switch is in "ON" position
2. Recline vacuum to operate brush
3. Remove obstruction or debris and
unplug cleaner to reset brush, see page. 14
4. Unplug cleaner to reset brush, see page. 14
5. Remove handle and reinstall
Remedies
1. Turn dial to lower setting
2. Make sure hose wand is fully seated in
base and diverter is in down position
3. Check assembly of upper and lower portions,
correctly position and snap into place
4. Empty dirt container
5. Follow instructions on pgs. 12-13 for
clearing clogs
6. Check and clean foam filter, check and
replace HEPA filter cartridge if needed
7. Make sure hose collar is twisted to
lock position