Table of Contents
Advertisement
M
aintenance and care
Cleaning the upper tank continued
4.
The inner cyclone and filtration disk may
be washed using a mild detergent. Be
sure it is completely dry before reassem-
bling or damage to your unit may result.
5.
Once cleaning is completed, reassemble
the filtration disk over the inner cyclone
by sliding it straight down on the top of
the inner cyclone and turning left. Be sure
to line up the tabs when reassembling for
proper installation.
6.
To replace the inner cyclone, slide it into the
upper housing. Be sure to line up the inner
cyclone by ensuring tabs on filtration disk
are positioned toward the front of the unit.
Push the inner cyclone in and rotate it to the
right until the locking tabs stop the rotation.
T
roubleshooting
Vacuum cleaner won't run
Possible causes
1.
Vacuum cleaner is not plugged in
2.
Damaged power cord
Vacuum cleaner and tools won't pick up dirt
Possible causes
1.
Incorrect height adjustment
2.
Hose not attached to suction opening
3.
Twist 'n Snap hose not securely attached
4.
Crack or hole in hose
5.
Broken or worn drive belt
6.
Rotating floor brush bristles worn
7.
Rotating floor brush jammed
8.
Clog in vacuum
9.
Dirt container full
10. Dirt container not installed properly
11. Filters are dirty
12. TurboBrush Pet is clogged or debris is wrapped around the brush roll
Vacuum cleaner is difficult to push
Possible causes
1.
Incorrect height setting
w w w . b i s s e l l . c o m
5.
6.
WARNING:
To reduce the risk of electric
shock, turn power OFF and
disconnect plug from electrical
outlet before performing
maintenance or
troubleshooting.
Remedies
1. Check electrical plug
2. Replace as necessary by an authorized service representative.
Remedies
1. Adjust powerfoot to correct height
2. Firmly push hose wand into hose wand base
3. Make sure Twist 'n Snap hose is snapped into locked position
4. Check hose and replace if needed
5. Replace drive belt, see pages 10-11
6. Replace brush
7. Remove brush and clean debris from brush ends
8. Clear clogs, see page 12.
9. Empty dirt container
10. Position correctly and lock in place
11. Check pre-motor and post-motor filters
12. See pages 11-12 for Maintaining TurboBrush Pet
Remedies
1. Adjust powerfoot to correct height setting
13
Advertisement
Table of Contents
