Connect The Water Hoses - Midea MLV45N1B Series User's Manual & Installation Instructions

Connect the water hoses

NOTE: The water supply hoses are not supplied with your washer and
must be purchased separately.
Caution
•
Use new water supply hoses. Using old hoses can result in leakage or
overflow that can damage your property.
•
Do not connect multiple water supply hoses together to increase the
length of the hose. Hoses connected this way can leak and cause
electrical shock. If a hose is too short, replace the hose with a longer,
high-pressure hose.
1.
Make sure that there are rubber washers inside the fittings at both ends
of each new water hose. Remove the rubber washers in faucet side and
replace with filters. Installing the water supply hoses without rubber
washers can cause water leakage.
Filters
must be present
Rubber washers
must be present
2. Tighten the hose and faucet fittings by hand until they are snug, then
tighten them an additional two-thirds of a turn with pliers or a wrench.
Pull the water supply hoses downwards to make sure that they are
connected securely.
Cold Hot
Faucets side
Use only
new hoses
Inlet valves side
19