Trouble Shooting - Omega OAL-100 Installation Instructions Manual

✓ Then release the door to close on its own.
✓ The value on the screen should be around 100 ±8.
✓ Press SEL button to save the settings.
You can activate the door and scroll through parameters to make adjustments as needed to Backcheck Speed, Overload,
Holding Time etc. as needed for your installation.
You can access to our YouTube channel to watch the sample installation videos with the following link.
https://www.youtube.com/channel/UCI2d_nzMlxHzSmhMQY_e3Fg/featured

8. Trouble shooting

Display does not indicate door closed
Display does not indicate door open
Hit ACT to begin
Possible problems
Door does not open
Door stops opening halfway
Door does not close
Electric strike does not release
Touch buttons do not respond
OMEGA AUTOMATICS 2020 v3.0.2
Fig 7.6.2
Possible solutions
-Check the power
-Check the ON/OFF switch
-Check the activation devices connection
-Check the display message
-Check magnet position
-Check sensor wire
-Check magnet position
-Check sensor wire
-Adjust overload setting
-Check for rubbing on floor and ceilings
-Check the magnets and sensor wire
-Check if the gearbox has tension
-Check wiring
-Check hardware
-Check strike connection
-Check strike voltage
-Clean fingers or wipe the touch buttons
19