Programming Heavy Duty (Xp) Operators - Omega OAL-100 Installation Instructions Manual

✓ The learning cycle does not register obstruction. Make sure that the path of the door is clear from obstacles.
✓ Once the learning cycle is completed and the door is in closed position the door operator is programmed.
✓ Connect activating device and run multiple test cycle to assure proper operation.

7.6 Programming Heavy Duty (XP) operators

✓ After you follow the abovementioned steps of installation of the push or pull arm application, turn on the operator
then control board should recognize the encoder.
✓ Press MENU touch button then press down touch button to see "Calibrate".
✓ Then press the SEL touch button.
✓ Screen shows "Hit ACT to begin".
✓ Press ACT button and manually push the door to the maximum opening position.
Door Opening
[Learning]
Fig 7.5.6
Calibrate
Fig 7.6.1
OMEGA AUTOMATICS 2020 v3.0.2
18