Bass Habit PP70.2 Owner's Manual page 4

POWER CONNECTIONS (FIG 1)
To get the very best performance out of your Bass Habit amplifier, carefully follow the
instructions below. Contact your local Bass Habit dealer to ensure that you have the correct
size wiring kit and fuse.
Power Connection (+12V):
Connect the 12V power supply cable after all other leads have been connected and secured.
Make sure the power supply cable is secured with a fuse 20-30cm from the positive 12V
battery terminal.
Ground Connection (GND):
Connect the amplifier Ground (GND) terminal to a solid point on the vehicles metal chassis, as
close to the amplifier as possible.
Scrape away any paint from this location; use a star-type lock washer to secure the connection.
Remote Connection (REM):
Connect the amplifier Remote (REM) terminal to the source unit remote turn on lead using a
minimum of 0.75mm2/18-gauge wire.
If your source unit does not have a remote signal output, connect the amplifier (REM) terminal
through a power switch button which can provide a +12V signal.
FIG 1: POWER CONNECTION