Table of Contents
Advertisement
P374 System User Manual
5.
5.1
5.2
Fault
Camera, lights
and LCD do not
operate
The LCD has
power but the
camera and lights
do not operate.
Cannot record
P374 pictures with
a video recorder
The picture is
always blurred no
matter where the
focus is set.
© Pearpoint Ltd
SPECIFICATIONS AND TROUBLESHOOTING
GENERAL EQUIPMENT SPECIFICATION
Weight:
Dimensions:
Voltage Requirements:
Power Consumption:
Environmental:
Input Connections:
Output Connections:
Working AMB Temperature -10° +40°c
TROUBLESHOOTING
This section deals with simple checks and procedures that can be performed by
the user. The table below shows some of the more common problems together
with the suggested course of action.
If any of the suggested remedies fail to resolve the problem, contact Pearpoint
for further advice.
Possible Cause
Power failure.
Power lead disconnected or
damaged.
Rod damaged or broken
Camera has come loose from
the connector
Ensure you have purchased
the correct unit
PAL for UK and Europe.
NTSC for US and Japan.
Check the condition of the
sapphire window fitted to the
camera's lens assembly, this
may be scratched to a point
where it starts to affect the
picture quality.
21Kg (46 lbs.)
915mm (36") H x 300mm (12") W x 600mm (23.5") D
100V - 240V AC 47-63 Hz; 12V DC
30 Watts maximum
Camera IP68; Coiler and Monitor IP55
Video - BNC; Power (100 - 240V AC) Power (12V DC)
Video – BNC
Solution
Check power supply
Reconnect power lead or, if
damaged, replace lead.
Inspect rod. If damaged or
broken, seek advice from
Pearpoint
Refit the Camera
Ensure you have connected
the video output from the
P374 to the video input of
your video recorder.
The UHF, VHF or aerial
socket will not work.
This is the only user-
replaceable item on the
system.
Please read the section on the
lens assembly within this
manual, this will explain how
to replace the lens.
Section 5
5-1
Advertisement
Table of Contents
