Step 8. Installing The Scsi Bus Terminator - IBM 7208 Setup And Operator Manual

2.1.8 Step 8. Installing the SCSI Bus Terminator
Make sure to install a SCSI bus terminator on the 7208 Tape Drive.
To install the terminator ( 1 in Figure 5), align it with the unused SCSI connector (in this case, 2 on the 7208 Tape Drive 3 ) and push in
until the terminator is seated. Tighten the thumbscrews finger tight.
+------------------------------------------------------------------------+
¦
¦
¦
¦
¦
¦
¦
¦
¦
+------------------------------------------------------------------------+
Figure 5. Attaching a Terminator to the 7208 Tape Drive.
the side. The thumbscrews are not shown.
Note: The terminator and the SCSI bus cable can be connected to either the top or bottom SCSI connector on the 7208 Tape Drive.
7208 Tape Drive Setup and Operator Guide

Step 8. Installing the SCSI Bus Terminator

PICTURE 8
¦ Copyright IBM Corp. 1998
2.1.8 - 1
¦
¦
¦
¦
¦
¦
¦
¦
¦
The view is from