Launch X-431 User Manual page 18

LAUNCH
(1) The BNC connector of the HT30 test line is connected to CH1 or CH2
(can be connected to both CH1 and CH2 as required), and the other
end (divided into two ways, red is signal line, black is ground line) is
connected to any two ways of the 6-way lead.
Remarks: When connecting the BNC connector, pay attention to the
insertion direction and rotate the connector after insertion to prevent
accidental drop.
(2) Insert the other ends (same color) of the connected two leads into the
bus terminal of the replaced sensor (select according to the male and
female type of the bus terminal).
4) Start the diagnostic tool and access the corresponding sensor module. Tap
Sensor in the job menu.
www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu
X-431 Module S2 User Manual
12