Step 3 - Tap Installation - Zenith HydroTap G5 Installation Instructions Manual

Step 3 – Tap installation
For more detail, refer to installation instructions supplied with the tap.
Position the tap so that water from
3.1
the spout will fall into a sink/tray
fitted with a drain
Cut a hole to suit your tap (35mm)
3.2
in the sink or benchtop using a
sheet metal hole punch or hole saw
(not supplied).
Push spacer on to the base of the
3.3
tap, with a light smear of silicone
sealant on the underside of the
spacer to ensure a watertight fit.
Pass the hoses down through the
3.4
hole and locate the tap in place.
From below the benchtop, push
3.5
the washer over the hoses and
threaded rod, then push the spider
clamp onto the threaded rod.
Check the tap is in the correct position,
then secure the fastening nut.
The tap tube length permits installation of a tap
3.6
height extension (not included).
For good fall of the water hoses, the tap tubes may
10 807042NZ v1.00 03.21 HydroTap G5 UltraCare Install Instruct
Installation instructions
be shortened using a PVC
cutter (conduit cutter).
Ensure the cut edges are
not sharp, before fitting
the hose.
Tap
Spacer
Benchtop
Washer
Spider clamp
Nut