Warnings And Precautions - Zenith HydroTap G5 Installation Instructions Manual

1. For continued safety of this appliance it must be installed,
operated and maintained in accordance with the
manufacturer's instructions.
2. This appliance may deliver water at high temperature. Refer
to the Plumbing Code of Australia (PCA), local requirements
and installation instructions to determine if additional delivery
temperature control is required.
3. Plumbing and electrical connections must be made in
accordance with local regulations and relevant standards. In AU/NZ:
Plumbing standard AS/NZS 3500 & Electrical Wiring Rules AS/NZS 3000.
4. This appliance must be earthed.
5. The power cord and general power outlet must be in a safe, accessible
position after installation. When positioning the appliance, ensure the
power supply cord is not trapped or damaged. If the power supply
cord is damaged it must be replaced by a Zenith service provider or a
qualified electrician.
6. Use only the power supply provided with the UV-C Module. An
ACM36US21 power supply is provided.
7. Do not locate multiple portable socket-outlets or portable power
supplies at the rear of the appliance.
8. Do not remove the cover of the appliance under any circumstances
without first isolating the appliance from the power supply.
9. This unit is designed for indoor use and must not be installed outdoors
or exposed to the elements of nature.
10. This unit must be installed with adequate clearances of 50mm on all
sides, and 200mm above. Additional means of ventilation is critical if the
vent kit, as supplied, cannot be fitted.
11. Flush water supply lines before any plumbing connections are made, to
prevent sediment from affecting operation.
12. This unit must not be cleaned by a water jet. This unit must not be
positioned in an area that may be cleaned by a water jet.
13. This appliance is intended to be used in: staff kitchen areas in shops,
offices and other working environments; farm houses and by clients in
hotels, motels and other residential type environments; bed and breakfast
type environments; catering and similar non-retail applications.
14. For safe operation, the HydroTap is designed to be installed,
commissioned and used within 48 hours. Should the HydroTap not be
required for an extended period of time (72 hours or more), do not fill
and commission the HydroTap until ready for first use.

WARNINGS AND PRECAUTIONS

807042NZ v1.00 03.21 HydroTap G5 UltraCare Install Instruct
!
03