Biasi RINNOVA ADAPTIVE 25S User Manual And Installation Instructions page 76

Figure 9.31
• Press the 14 key for 1 second (Figure 9.28)
to enter the selected parameter. The display
will show the following (13=M300V.2025 SM,
14=M300V.2530 SM or 15=M300V.3035 SM)
(Figure 9.32).
Figure 9.32
• By pressing the keys 13 and 15 simultane-
ously (Figure 9.28) exits the level without
changing the value (return to the previous
level Figure 9.31).
• Scroll through the various parameters by
pressing the keys 13 (back) or 15 (forward),
until P02, which alternates with the parame-
ter value, appears on the LCD display.
• Repeat the previous steps to display the val-
ue and proceed to the next parameter.
• Set the following parameters:
- 76 -
MAINTENANCE
PARAMETERS
Type of gas
User interface
Type of domestic hot wa-
ter exchanger
Type of primary circuit
control device
Type of DHW flow con-
trol device
DHW
mode (at end of DHW)
(M300V.2025
M300V.2530 SM)
DHW
mode (at end of DHW)
(M300V.3035 SM)
To exit the parameters menu:
• wait 15 minutes without pressing any key;
• switch off the electric power supply;
• press the 13 and 15 keys simultaneously for
5 seconds (Figure 9.28) (return to previous
level).
Enter the CAF menu (Automatic calibration)
and start calibration. See paragraph "Automat-
ic calibration of the gas valve" on page 62.
LCD
P02
P03
P04
P05
P06
post-heating
SM -
P25
post-heating
VALUE
G20 = 00
G31 = 01
00
00
03
03
01
02