Page 1
Installation and service must be performed by a qualified installer, service agency or the gas supplier. Manufactured by: Distributed By: Biasi S.p.A. Quincy Hydronic Technologies, Inc. Verona, Italy 80 Rochester AVE. Suite # 12 Portsmouth, NH 03801 Phone: 603-334-6400 Fax: 603-334-6401 RIVA HEAT ONLY USER MANUAL - REV A...
Page 3
Only has been tested to standard CSA 4.9 and is CSA compliant. This Riva boiler has a 2 year warranty, a copy of which is provided with the boiler. Please be sure to return the warranty registration card as the warranty will be void without your boiler's serial numbers (located on the ratings label affixed to the boiler), date of installation and the name of your installer being on record in our files.
Do not use this boiler if any part has been under water. Immediately call a qualified service technician to inspect the boiler and to replace any part of the control system and any gas control which has been under water. RIVA HEAT ONLY USER MANUAL - REV A...
Page 6
VACATE THE PREMISES IMMEDIATELY AND CONTACT A QUALIFIED HEATING SERVICE COMPANY OR THE GAS COMPANY OR THE FIRE DEPARTMENT. ONLY QUALIFIED, LICENSED SERVICE CONTRACTORS SHOULD PERFORM WORK ON YOUR BIASI RIVA HEAT ONLY BOILER. RIVA HEAT ONLY USER MANUAL - REV A...
E. ANSI/ASME - CSD-1 The above codes are available from: National Fire Protection Association (NFPA) CSA International Battery March Park 8501 E. Pleasant Valley Road Quincy, Massachusetts, 02269 Cleveland, OH 44134-5575 http://www.nfpa.org http://www.csa-international.org RIVA HEAT ONLY USER MANUAL - REV A...
1. General Information The Riva Heat Only is a high efficiency, non-condensing, wall mounted gas boiler which provides central heat. The boiler features a gas valve which modulates the energy input from 44,000 BTU/h to 108,000 BTU/h. The boiler is shipped fully assembled. All units are pressure and combustion tested at the factory prior to shipping.
Lack of burner ignition (no ignition signal from the full sequence ignition device Ignition gas pressure adjustment Minimum gas pressure adjustment Flashing lamp, alone Flashing lamp, Lamp OFF Lamp ON or simultaneously alternate with with another lamp. another lamp RIVA HEAT ONLY USER MANUAL – REV A...
Figure 5.3 according to actual system requirements. These adjustments must be carried out by a qualified person; therefore we advise you to contact your installer or Service Agent. RIVA HEAT ONLY USER MANUAL – REV A...
(see section 3.3 for pipes) • Empty the water circuit, if necessary, as shown in the installation, operation and service instructions manual in the maintenance section. RIVA HEAT ONLY USER MANUAL – REV A...
• exhaust fume duct and flue; • pressurization of the expansion vessel; • filling up of the central heating circuit; • bleeding of air from the central heating system; • general check of the appliance’s operation. RIVA HEAT ONLY USER MANUAL – REV A...
• It is necessary to fill up the appliance with water again, so as to raise the pressure to an adequate level as described in the section 5.2 of this manual. • If filling up with water has to be done very frequent, have the system checked for leaks. RIVA HEAT ONLY USER MANUAL – REV A...
Authorised Service Person. In case of problems other than those mentioned here, switch off the boiler, as described in Section 5.5 on page 14 and call a competent and responsible service person. RIVA HEAT ONLY USER MANUAL – REV A...
RESIDENTIAL HOT WATER BOILERS: Biasi warrants that 4. Improper boiler application or adjustments, control settings, the copper tube heat exchanger of the RIVA boilers are free care or maintenance. from defects in material and workmanship for 5 years from the 5.
Need help?
Do you have a question about the riva and is the answer not in the manual?
Questions and answers