Starkey SurfLink Media Quick Tips

QuickTIPS
SURFLINK MEDIA: SETUP
PRODUCT AVAILABILITY:
ENABLING SURFLINK MEDIA IN INSPIRE
1. Launch Inspire 2014.3
2. Connect and detect hearing aids to the fitting computer via the
appropriate programming accessories. Refer to the Boots and
Cables Programming Guide available via Inspire Online for additional
information regarding connecting the hearing aids.
3. Select
New Session
NOTE: Auto Path will default to launching automatically for hearing
aids that have not been previous read by Inspire.
4. Select
Accessories
5. Select
SurfLink Media
6. Select which memories will automatically accept a streamed signal
by selecting the boxes adjacent to the memory name under
Streaming AND select
Streaming for each memory if desired.
7. If using Advanced SurfLink Remote Control or SurfLink Mobile along
with SurfLink Media:
» Advanced SurfLink
-Enter SurfLink Remote Address in Configure SurfLink
Remote Control and select
-Ensure the Favorite Button is set to
» SurfLink Mobile:
-Ensure the Favorite Button is set to Stop/Start Audio.
NOTE: Stream Boost defaults ON (Stream Boost is only available
for the Z Series products). Deselect Stream Boost to disable.
Z Series, 3 Series wireless, Xino wireless, Wi Series
or higher.
on the Get Started Screen and select
on the left navigation bar.
under SurfLink Accessories.
Hearing Aid Microphone Setting While
Remote:
Sync.
Stop/Start Audio
Streamboost is available in Z
Series products to deliver an
automatic and enhanced sound
quality experience to the patient
any time a streamed media input
is detected.
Start.
Media
Stream.
Enable SurfLink Media
Configure Streaming Behavior