Table of Contents
Advertisement
2.9
Installing a floppy disk drive
The V-Series P5V900 system comes with one 3.25-inch drive bay for a
floppy disk drive.
To install a floppy disk drive:
1.
Remove the front panel cover.
2.
Carefully insert the floppy disk drive into the floppy drive bay until the
screw holes align with the holes on the bay.
3.
Secure the floppy disk drive with two screws on both sides.
4.
Connect the floppy disk drive signal cable to the signal connector at
the back of the drive.
5.
Connect the other end of the signal cable to the floppy disk drive
connector on the motherboard. See page 4-6 for the location of the
floppy disk drive connector.
6.
Connect a 4-pin power cable from the power supply unit to the power
connector at the back of the floppy disk drive.
2-20
3
3
2
Power cable
Floppy ribbon
cable
Chapter 2: Basic installation
Advertisement
Table of Contents
