Table of Contents
Advertisement
2.6.2
Installing / Uninstalling a card reader / a floppy disk
drive
Installing a card reader
To install a card reader:
1.
Insert the card reader to the 3.5 inch drive bay and carefully push the card
reader until its screw holes are aligned with the holes on the supporting
stand.
2.
Pull the retention brackets on both sides of the bay outward and align the
hard disk to the retention brackets.
3.
Press the retention bracket locks until they are parallel to the card reader.
4.
Connect the power cable and the signal cable..
Installing a floppy disk drive
Follow the same instructions as shown in the section of "Installing a card reader" to
install a floppy disk drive.
2-16
3
2
1
3
2
Chapter 2: Basic installation
Advertisement
Table of Contents
