4.5.3
RIP
The Routing Information Protocol (RIP) is documented in
RFC 1388
and
RFC
protocol that exchange routing information using UDP packets.
RIP configuration includes the following information:
RIP process: enable/disable. RIP advertisements are sent and
received only when the RIP process is enabled.
RIP version: v1/v2/both. To specify what RIP Version packets are to
be sent and received.
RIP interfaces: To specify which routing entry should be advertised
along the networks. Note that only the running up Layer 3
interface(s) (in connected status) will be able to advertise routing
information,while the interface(s) in disconnected and down status
will not.
GigaX Series L3 Managed Switch User Guide
Figure 18. Static Route
1723. In short, RIP is a distance-vector routing
RFC
1058,
41