Advertisement
Manual Supplement
Under 2 USB connectors, replace the Note with:
A USB stick must not be pulled out while the USB LED flashes. This can cause permanent
damage to the storage media. Only remove the USB stick while the USB LED is OFF or
statically ON. Do not use the USB and data connection at the same time.
Stored data can be erased by holding down the Reset button while switching on the
instrument. This may be useful if the memory is full and may also resolve connectivity
issues.
On page 1-18, remove the first paragraph Compact Flash Card.
On page 2-4, under Simple Measurements – Function Check, replace the first sentence after
Connect device with:
Connect your computer and the recorder with the Crossover Ethernet cable (do not use the gray plug).
On page 4-4, under Replacement of Battery Pack, replace the 4
•
For replacement of the battery pack, use only the original spare part
(PN 3114277).
On page 5-3, under General Specifications, Ambient condition, replace Operating temp. range
with:
Operating temperature range ...........0 °C to +50 °C, 32 °F to +122 °F (Startup temp ≥5 °C (41 °F)).
On page 5-3, under General Specifications, remove the Quality system, Protection, Electrical
safety, Environmental, and Emissions/Immunity entries and add:
IP Rating ..........................................IEC 60529: IP40
Safety...............................................IEC 61010-1: Overvoltage Category III, Pollution Degree 2
Electromagnetic Environment ..........IEC 61326-1: Basic
Electromagnetic Compatibility ..........Applies to use in Korea only. Class A Equipment (Industrial Broadcasting &
Radio Frequency Emissions ............IEC CISPR 11: Group 1, Class A.
On page 5-5, replace Flicker with:
Flicker
On pages 6-7, 6-11, 6-15, 6-18, 6-22 and 6-25 replace the Safety Standards with:
•
IEC 61010-1: Pollution Degree 2
•
IEC 61010-031
•
IEC 61010-2-032: 300 V CAT IV
Note
IEC 61010-2-030: As specificed by attached accessory.
Communication Equipment)
[1] This product meets requirements for industrial (Class A) electromagnetic
wave equipment and the seller or user should take notice of it. This
equipment is intended for use in business environments and is not to be
used in homes.
Group 1 have intentionally generated and/or use conductively coupled radio-
frequency energy which is necessary for the internal functioning of the
equipment itself.
Class A equipment is suitable for use in non-domestic locations and/or directly
connected to a low-voltage power supply network.
As per IEC 61000-4-15:2010
10 min (PSt), 2 h (Plt)
4
th
bullet with:
[1]
1760 Users
2/18
Advertisement
