Dimplex DGR32PLP Installation And User Manual page 5

Table of Contents

Advertisement

Available languages

Available languages

IMPORTANT INSTRUCTIONS
Heater Installation Codes
The installation must conform with local codes or, in
the absence of local codes, with either the National
Fuel Gas Code, ANSI Z223.1/NFPA 54, Natural Gas
and Propane Installation Code, CSA B149.1, or
Propane Storage and Handling Code, B149.2.
Liquid Propane (LP) Pressure
The gas manifold supply pressure must be
regulated at 11" water column using the supplied
regulator. The minimum inlet pressure to the
regulator from the tank is 10 psi and maximum
pressure is 150 psi.
Replacement Parts
Use only Dimplex replacement parts. The use of any
part that is not a Dimplex replacement part can be
dangerous and will also void your product warranty.
SAVE THESE INSTRUCTIONS
WARNING
!
Never use your gas heater in a garage, porch, shed,
breezeway or any other enclosed area.
Never obstruct the flow of ventilation air around
your gas heater housing.
WARNING
!
Failure to comply with these instructions could result
in a fire or explosion that could cause serious bodily
injury, death or property damage.
Before using this gas appliance read all instructions
and perform all gas leak-check procedures even if
the product was pre-assembled by the retailer or
manufacturer.
5

Advertisement

Table of Contents
loading

Table of Contents