Dimplex DGR32PLP Installation And User Manual page 13

Installation
4 4
Assembling the upper assembly
1. Lay the upper assembly on a non-abrasive surface, such as the carton or a table. Remove the 8 pre-
installed screws from the back panel of the upper post. These are identical to hardware A. (Figure 7)
2. Insert the regulator with hose through the upper post. (Figure 8)
3. Re-install the back panel of the upper post. (Figure 9)
4. Insert the middle post in the upper post and secure it using 6 x hardware A. (Figure 9)
5. Secure the heater to the upper post using hardware D, E, F, and G as shown. (Figure 10)
A
Figure 7
Figure 9
Previously removed
screws (×8)
A
×6
×6
Pre-installed
screws (×8)
D
E
Figure 8
Regulator
with Hose
Figure 10
E
D
F
G
F
G
13