Troubleshooting - Spirit CT 900 TFT User Manual

TROUBLESHOOTING

Before contacting your dealer for aid, please review the following information. It may save you
both time and expense. This list includes common problems that may not be covered under
the treadmill's warranty.
PROBLEM
Display does not light
Treadbelt does not stay centered
Treadmill belt hesitates when walked/run on
Motor is not responsive after pressing start
Treadmill will only achieve approximately 7mph
/10 kph but shows higher speed on display
Treadmill triggers on board circuit or
local circuit breaker
Computer shuts off when console is
touched (on a cold day) while walking/running
SOLUTION/CAUSE
1) Tether cord not in position.
2) Circuit breaker on front grill tripped. Push circuit breaker
in until it locks.
3) Plug is disconnected. Make sure plug is properly
connected.
4) Breaker panel circuit breaker may be tripped.
5) Treadmill defect. Contact your dealer.
The user may be walking while favoring or putting more
weight on either the left or right foot.
See General Maintenance section on Treadbelt Tension.
Adjust as necessary.
Reset power. If still no good contact service.
This indicates motor should be receiving more power to
operate correctly. Do not use an extension cord. A minimum
of 100Vac or 200Vac current is required.
High belt/ deck friction. See General Maintenance section
on cleaning the deck. Contact customer service.
Treadmill may not be grounded. Static electricity is
"crashing" the computer. Contact customer
service.
84