Opening The Burner; Closing The Burner - Riello RLS 160/M MX Installation, Use And Maintenance Instructions

7.3

Opening the burner

Disconnect the electrical supply from the burner
by means of the system main switch.
DANGER
Close the fuel shut-off valve.
DANGER
Wait for the components in contact with heat
sources to cool down completely.
7.4

Closing the burner

Refit following the steps described but in reverse order; refit all
burner components as they were originally assembled.
After carrying out maintenance, cleaning or
checking operations, reassemble the cover and
all the safety and protection devices of the burner.
20148049
Maintenance
 Loosen the screws 1) and remove the hood 2)(Fig. 47).
 Disconnect the light oil pipes 7)(Fig. 47).
 Disengage the articulated coupling 8) from the graduated
sector 9).
 Remove the screws 10) from the two slide bars 4).
 Assemble the two extensions on the sliding bars 4).
 Refit the screws 10) on the extensions.
 Remove the screws 3) and move the burner backwards by
about 100 mm on the slide bars 4)(Fig. 47).
Disconnect the electrode cables, then completely retract the
burner.
At this point it is possible to extract the inner part 5) after having
removed the screw 6)(Fig. 47).
40 GB
20159584
Fig. 47