Installation Procedure - Toto Aquia TS416A Installation And Owner's Manual

Showerhead with arm

Hide thumbs

Table of Contents

Available languages

NO TE: Be sure to thoroughly clean and remove all debris from the water supply pipe

before it is installed. This will prevent clogging in the spray outlet.

INSTALLING MODEL TS416A:

1) Slide the escutcheon onto the

shower arm (see Illustration 1).

2) Wrap pipe tape around the threads

of the shower arm and fasten it to the

supply elbow (see Illustration 1).

3) Thread the showerhead onto the

shower arm until it is tight (see

Illustration 1).

4) Slide the escutcheon until it is flush

against the wall (see Illustration 2).

NO TE: Do not use the showerhead as

leverage to tighten the shower arm.

This can damage the showerhead.

INSTALLING MODEL TS624A:

1) Slide the escutcheon onto the shower

arm (see Illustration 1).

2) Wrap pipe tape around the threads

of the shower arm and fasten it to the

supply elbow (see Illustration 1).

3) Loosen the two set screws at the

top of the ball joint. Ensure that the

gasket is in place in the ball joint,

then thread the shower arm onto the