Wing Skid Shoe - Land Pride RC2512 Operator's Manual

Section 5: Maintenance & Lubrication
Skid Shoes
!
CAUTION
Excessive wear on skid shoes may cause inadequate operation
of cutter and create a safety hazard.
There is one skid shoe mounted on each wing deck and
two skid shoes mounted on the center deck. Check all
skid shoes for wear and replace if necessary. Order only
genuine Land Pride parts from your local Land Pride
dealer.
Center Deck Skid Shoes
Refer to Figure 5-6:
Replace skid shoes as follows:
1. Remove 1/2" whiz nuts (#3), 1/2" carriage bolts (#2),
and skid shoe (#1) from cutter.
2. Attach new skid shoe (#1) to cutter with existing
1/2" round head square neck bolts (#2) and secure
with 1/2" hex whiz nuts (#3). Tighten hex whiz nuts to
the correct torque.
3. Repeat on opposite side of center deck.

Wing Skid Shoe

Refer to Figure 5-7:
IMPORTANT: Excessive wear on skid shoes can
weaken cutter side panels and cause damage that
will require extensive repairs. Always replace skid
shoes at the first sign of wearing thin.
Replace wing skid shoes as follows:
1. Remove 3/8" hex whiz nuts (#3), 3/8" plow bolts (#2),
and wing skid shoe (#1) as shown.
2. Plow bolts should be checked for wear and replaced
if necessary.
3. Attach new skid shoe (#1) to cutter with
3/8" -16 GR5 plow bolts (#2) and secure with 3/8"
hex whiz nuts (#3). Tighten hex whiz nuts to the
correct torque.
4. Repeat steps 1 through 3 on opposite wing section.
28 RC2512 Rotary Cutter 330-725M
Table of Contents
Item Part No.
1 330-697H SKID SHOE
2 802-106C RHSNB 1/2-13X1 1/2 GR5
3 803-169C NUT HEX FLG LOCK 1/2-13 PLT
Item Part No.
1 312-602D WING SKID SHOE
2 802-603C PLOW BOLT, 3/8" - 16 x 1" grade 5
3 803-198C HEX WHIZ NUT, 3/8"-16 PLT
Part Description
Center Skid Shoe
Figure 5-6
Part Description
Wing Skid Shoe
Figure 5-7
30631
30632
3/27/15