Land Pride RC2512 Operator's Manual page 37

Section 5: Maintenance & Lubrication
Accessing CV Driveline Joints
Refer to Figure 5-8 on page 34:
There are two ways the constant velocity driveline joints
shown in Figure 5-8 can be accessed for lubrication. One
is through holes in the driveline shield and the other is to
slide the shields back to expose the grease zerks.
Lubrication Through Access Holes
1. Refer to Figure 5-9: Rotate driveline shield until
holes in shield align with grease zerks in CV joint.
2. Apply proper amount and type of lubrication. Refer to
"Constant Velocity Main Driveline Joints" on page
34 for quantities and type of lubrication.
Rotate Driveline Shield to Align
3-Holes in Shield With Grease Zerks
Lubrication Through Three Holes In Driveline Shield
Figure 5-9
3. Refer to Figure 5-10: Rotate driveline shield 180
until holes on opposite side of shield aligns with
remaining grease zerks in CV joint.
4. Repeat step 2 above on any grease zerks that were
not greased in step 2.
5. Steps 1 thru 2 can be repeated to lubricate universal
joint on opposite end of driveline. (Opposite end of
driveline has only one grease zerk.)
Rotate Driveline Shield to Align
2-Holes in Shield With Grease Zerks
Lubrication Through Two Holes In Driveline Shield
Figure 5-10
Lubrication By Sliding Driveline Shields Back
1. Refer to Figure 5-11: With a flat bladed screwdriver
or similar tool, pry top of red locking tab up.
2. Refer to Figure 5-12: Rotate white locking ring fully
counterclockwise to the position shown.
3. Refer to Figure 5-13: Pull back on driveline shielding
until CV joint is exposed.
3/27/15
Table of Contents
Red Locking Tab
Red Locking Tab
33992
o
Driveline Shield
Pulled Back
Slide Driveline Shield Back To Expose Grease Zerks
33993
4. Apply proper amount and type of lubrication. Refer to
"Constant Velocity Main Driveline Joints" on page
34 for quantities and type of lubrication.
5. Slide driveline shield back to its operating position.
6. Refer to Figure 5-11: Rotate white locking ring
clockwise and press locking tab down until it snaps in
place as shown.
7. Steps 1 thru 6 can be repeated to lubricate universal
joint on opposite end of driveline.
White Locking Ring
Snapped Down
Positioned On Right Side
Into Position
of Red Locking Tab
Locked Driveline Shield
Figure 5-11
White Locking Ring
Pried Up Rotated Counterclockwise
Unlocked Driveline Shield
Figure 5-12
Exposed CV Grease Zerks
Figure 5-13
RC2512 Rotary Cutter 330-725M
33994
33995
33996
35