Inter-Message Delay; Inter-Character Delay; Message/Block Mode Selection - Adesso NuScan 2100 Series Programming Manual

Start of Configuration
DATA REDUNDANT CHECK
The option allows you to set
decoder data redundant
check.

INTER-MESSAGE DELAY

These series of scanners allow you to add a delay
between two consecutive messages. This delay will be
added before each data transmission.
100 msec
500 msec
1 Second
Enable
Disable
None
10

INTER-CHARACTER DELAY

This option governs delay time between consecutive
characters. Scanning the following labels can alter the
delay time.
10 msec
20 msec
50 msec

MESSAGE/BLOCK MODE SELECTION

This option allows you to treat scanned data as either an
independent message or a block message.
message mode, the data scanned will be transmitted
immediately. In block mode, the data scanned will be
appended to the message buffer if the scanner is
programmed in block mode. A block of message will
only be transmitted after a "Send" command is entered.
This mode is only available when the scanner is working
with code 39 labels.
character as the " Send" command.
Message
None
You are free to choose any
Block
End of Configuration
11
In the