Hdd - Acnodes Panel PC 1000 User Manual

PANEL PC 1000 All-in-One PANEL PC User's Manual
3.3

HDD

The standard PANEL PC 1000 already builds in a 2.5" hard disk drive.
If the user intends to remove the existing device for repair or for a
higher-capacity one, then follow the installation instructions below.
1. Take out the screws and remove the HDD bracket.
Mounting orientation of the HDD brackets on PANEL PC
1000 are not similar to each other. The four screws
mounting the PANEL PC 1000 HDD bracket sits at the
bottom of the bracket.
2. Reinstall the new hard disk driver to the HDD bracket and
screw the HDD bracket to the system compartment again.
The four rubber stands act as cushions to lessen the
vibration that usually causes damage to mechanical
devices like a hard disk driver.
3. Use the IDE cable to connect the HDD to the IDE pin
connector. Match pin 1 of the HDD and the pin 1 of the
cable.
System Installation 11