Acnodes PC 1150 Installation Manual

PANEL PC 1150 INSTALLATION GUIDE
I. CHECK-LIST
PANEL PC 1150 system unit x 1
!
Mounting bracket x 6
!
Screw kit
!
PS/2 keyboard adapter cable x 1
!
Do not attempt to apply power to the system if there is damage to any of its components.
II. INSTALLATION
CPU, HDD, and DRAM Installation
The standard PANEL PC 1150 system already builds in a Pentium-level CPU, and a 3.5" (or optional 2.5") hard disk
drive. SBC8354-based systems feature two 72-pin SIMM sockets supporting system memory up to 128MB. SBC8360,
on the one hand, provides one 168-pin DIMM socket that supports system memory up to 256MB (buffered)/128MB
(unbuffered).
1. Remove the 3 screws securing the riser card assembly's back cover. Take off the cover by sliding it outward and pulling it upwards as pointed by the
arrows. If your system does not come with a riser card assembly, proceed to step 2.
2. Another 6 screws, located on the upper perimeter (3) and lower half (3), needs to be removed. These screws are the screws bolting the system's rear
cover to the main unit.
3. Take off the system's rear cover (and the riser card assembly).
4. See the illustration for the exact locations of your HDD, CPU and DRAM sockets.
After making the necessary upgrades or modifications to your HDD, CPU, and DRAM, restore the system back to its original form by following instructions 4 to
D R A M
CD-ROM and FDD Installation
Remove the 3 screws securing the riser card assembly's back cover. Take off the cover by sliding it outward and pulling it
1.
upwards as pointed by the arrows. If your system does not come with a riser card assembly, proceed to step 2.
Another 6 screws, located on the upper perimeter (3) and lower half (3), needs to be removed. These screws are the screws
2.
bolting the system's rear cover to the main unit.
You may now take off the system's rear cover (along with the riser card assembly).
3.
See the illustration for the exact locations of your CD-ROM and FDD slots. There are 2 screws mounted on the cover of each
4.
slot. Remove these screws. Store the covers at a safe place for future use.
Mount the FDD and CD-ROM drives as shown on the illustration. Make sure to secure the drives using all 8 screws located on
5.
both sides of the expansion bay.
After completing the installation, restore the system back to its original form by following instructions 3 to 1.
6.
ACNODES.COM
INFO@ACNODES.COM
C P U
PANEL PC User's Manual, System Board User's Manual , Quick
!
Installation Guide x 1Driver & Utilities CD-ROM x 1 (Product
Information CD-ROM)
Mini jumper 2P x 10
!
H D D
Bracket