Table of Contents
Advertisement
VertX V1000 (CS) Quick Installation Guide
1 .5
M ode m
The VertX controller will automatically answer incoming calls when an external serial modem is attached to
the RS-232 port 1.
1 .5 .1
M ode m Se t u p Re qu ir e m e n t s
•
External Modem (not included). The modem must be selected from the following approved HID modem
list:
o Zoom V.90 56 K Fax Modem, Model 2949 (external modem uses phone jack)
o U.S. Robotics V.92 56K Fax Modem, Model 5686 (external modem uses phone jack)
o Telular GSM 850/1900, Model 1C02A160 (external cellular modem)
• RS-232 Serial modem cable (not included)
• HID Serial Adapter cable (included with the VertX controller)
• AC electrical outlet or surge protector for supplying power to the modem
• Analog phone line
• VertX V1000 controller
1 .5 .2
Ph ysica l M ode m Se t u p
1. Connect the RS-232 Serial modem cable
(purchased separately) 9 or 25-pin
connector into the back of the modem.
2. Connect the other end of the RS-232 Serial
modem cable (9-pin connector) into the HID
Serial Adapter cable (P/N 70007). In
addition, connect the HID RS-232 Serial
Adapter cable into P17 RS-232 Port 1.
3. Connect one end of the phone cord
(included with the modem) into the TELCO
or LINE jack on the back of the modem and
plug the other end into an analog telephone
wall jack.
4. Plug the power adapter (included with modem) into a surge protector or electrical outlet. Make sure
you use the power adapter that came with the modem, as others may be of different voltages and
could damage your modem.
5. Turn on the modem. This is usually done by using a switch located next to the status lights. There
may also be a power switch located on the back of the modem.
October 2006
© 2006 HID Global Corporation. All rights reserved.
Page 10 of 20
Hide quick links:
Advertisement
Table of Contents
