Table of Contents
Advertisement
VertX V1000 (CS) Quick Installation Guide
CAUTION: During the process of rebooting the controller, all network configuration information will
be overwritten and returned to the original defaults.
4. Configure the controller for your installation parameters. See 3.1 VertX Communications, page 12.
F i r e w a l l
If the VertX controller is being installed where it communicates through a firewall, then the firewall may need
to be configured to allow TCP data transfer on the specified port(s).
1. Before starting, ensure that any pop-up blocker software is disabled on the computer.
2. Open the following ports on the firewall.
•
•
If you are not familiar with configuring a firewall for a network, contact the Network/IT administrator or
manager.
CAUTION: If the firewall is not configured properly the controller may not communicate with the host.
Ce n t r a l S t a t i o n A u t o m a t i o n P r o v i d e r s
Central Station Automation Software
Dice Corporation
Bold Technologies
Micro Key Software
Patriot Systems
Perform the following steps if the central station requires the
1. Open your Internet Browser.
2. Enter the V1000 IP address or host name into the
3. Click
4. Change the Here I am Interval
5. Click Submit and the change will become activated once the controller is rebooted.
6. Close the browser window(s) when completed.
October 2006
connection_port (4070)
computer.
listen_port (4050) TCP incoming. This port must be open when using selected
applications. See the Central Station for information.
.
from
0
© 2006 HID Global Corporation. All rights reserved.
TCP outbound.
This port must be open on the Host
Here I am Interval
60
60
3600
Pending
Here I am Interval
Address field.
(default) to the new parameter.
to change.
Page 16 of 20
Hide quick links:
Advertisement
Table of Contents
