Table of Contents
Advertisement
Fault
Steam is not visible in
Hot air mode and grill
combined operation.
Drip tray is empty
after steam operation.
White limescale
particles are in the
drip tray.
Low water consump-
tion in combined op-
eration. Especially
when combining 3
functions.
17.2 Information on display panel
Fault
The message E0532
appears on the dis-
play
The message E5005
appears on the dis-
play
18 Disposal
Find out here how to dispose of old appliances cor-
rectly.
18.1 Disposing of old appliance
Valuable raw materials can be reused by recycling.
Dispose of the appliance in an environmentally
▶
friendly manner.
Information about current disposal methods are
available from your specialist dealer or local author-
ity.
19 Customer Service
If you have any queries on use, are unable to rectify
faults on the appliance yourself or if your appliance
needs to be repaired, contact Customer Service.
Function-relevant genuine spare parts according to the
corresponding Ecodesign Order can be obtained from
Customer Service for a period of at least 10 years from
the date on which your appliance was placed on the
market within the European Economic Area.
Cause and troubleshooting
Steam is not visible in every temperature range. The hotter the steam, the less visible it is.
No action required.
▶
In normal steam operation and steam combined operation, the condensation is collected by
the glass plate on the bottom and the grey drip trough in the bottom plate. It will not get into
the drip tray.
No action required.
▶
The drip tray is used only for the rinse cycle and descaling process, not for normal
steam operation and steam combined operation.
During rinsing and descaling, fine limescale particles are loosened from the boiler.
Check the water hardness setting.
1.
Run the descaling programme at the specified intervals.
2.
Descale the appliance as described in the instruction manual for your appliance.
▶
In steam combined operation, especially when combining 3 functions, only a small amount
of steam is used in some cases. This means that only a small amount of water is used from
the fresh water tank.
No action required.
▶
Cause and troubleshooting
Dirt on the control panel is causing a touch field to be permanently active.
Switch off the appliance.
1.
Clean the control panel.
2.
Switch the appliance back on.
3.
If this fault recurs immediately after switching back on, call our customer service.
▶
The steam function has been activated multiple times with an empty water tank.
Before next use, make sure that the water tank is filled with cold water and fully inserted
▶
in the tank recess.
If this fault recurs, call the after-sales service.
▶
This appliance is labelled in accord-
ance with European Directive
2012/19/EU concerning used elec-
trical and electronic appliances
(waste electrical and electronic equip-
ment - WEEE).
The guideline determines the frame-
work for the return and recycling of
used appliances as applicable
throughout the EU.
Note: Under the terms of the manufacturer's warranty
the use of Customer Service is free of charge.
Detailed information on the warranty period and terms
of warranty in your country is available from our after-
sales service, your retailer or on our website.
If you contact Customer Service, you will require the
product number (E-Nr.) and the production number
(FD) of your appliance.
Disposal en
31
Advertisement
Table of Contents
