Page 1
John Lewis Emily Bed King Thank you for purchasing this Emily bed. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. For product support or spare parts please call the John Lewis Helpline;...
Page 2
Fittings and parts checklist M4 Allen Key x 1 M6 X 25mm Bolt x 2 Wide Centre Caps x 8 M5 Allen Key x 1 Wide Side Caps x 16 Centre Plastic Caps x 8 Side Plastic Caps x 16 Headboard x 1 Footboard x 1 Side Rails x 2...
Page 3
Step by step assembly instructions Step One Place Wooden Legs (7) into the holes in the underside of the Headboard (1) and Footboard (2) as per diagram below and twist into place so they are fully secured. Wooden Leg Pre-inserted Nut Head/Foot Board (7) x 4...
Page 4
Step Three Insert Centre Rail (6) into the brackets in the centre of the Headboard (1) and Footboard (2). Push down fully and secure in place using M6 x 25mm bolt (E). Tighten bolt with Allen Key M4 (A). You can now tighten the bolts at the Side Rails from previous step (Step Two) so all fastenings are now tightened.
Page 5
Step Four With the curved side facing upwards, insert 2 slats into a centre cap then into 2 side caps on either end(x16). (Please note the Wide Slats must be inserted with the Wide Centre Caps (F) and Wide Side Caps (G)). Repeat this process for all slats. Note: Please see the Diagram 1 below to arrange the slat with the correct system).
Care and Maintenance This Emily bed should be cleaned using a soft damp cloth and dried immediately. Do not use a very wet cloth or allow any liquid contact for a long period of time as this can permanently damage the surface.