Page 1
Showwood Bed Double Thank you for purchasing this Showwood Bed. Please read the instructions carefully before use to ensure safe and satisfactory operation of this product. PRE-ASSEMBLY PREPARATION Please ensure instructions are read in full before attempting to assemble this product.
Page 2
Fitting and parts checklist Fittings M6 x 55mm Bolt x 4 M5 Allen Key x 1 M4 Allen Key x 1 Wide Centre Caps x 8 Centre Caps x 7 Wide Side Caps x 16 M8 Washer x 2 Side Caps x 14 M6 X 40mm Bolt x 8 M8 Spring Washer x 4 M6 Washer x 10...
Page 3
Step One Attach the Wooden Base (8) into the side on the Headboard (1) using the M6 x 55mm Bolt (G), and M8 Washer (J). Do not tighthen the bolt until all part attached. M10 x Washer(J) M6 x 55mm(G) M4 (B) Wooden Base M6 x 55mm x 2...
Page 4
Step Three Now attach the Footboard (2) to the Side Rails (3) using M8 x 50mm (L) with M8 Spring Washer (K) and hand- tighten to loosely secure parts together as shown in Fig.4. Do not tighthen bolts with M5 Allen Key (A) until you have inserted the Centre Rail in the next step.
Page 5
Step Five Starting with the Headboard (1), insert the Legs (7) into the pre-drilled holes on the underside of the Headboard (1) and twist to secure, as shown in the diagram below. Note: Before proceed to the next step, ensure the wooden base on each part are parallel towards each other by adjusting the bolt on the bottom.
Care and Maintenance This bed should be cleaned using a soft, damp cloth and dried immediately. Do not use a very wet cloth or allow any liquid contact for a long period of time as this can permanently damage the surface. Do not use detergents and do not rub as this can cause permanent damage.