Dometic RM2620 Installation And Operating Instructions Manual page 6

Refrigerator for lp-gas & electric operation
Table of Contents

Advertisement

CLEARANCES
Minimum clearances (in inches) to combustible materials:
Top (G)
0
Side (K)
0
Bottom (L)
0
Rear (M
1
)
0
1
M: The distance between the rearmost part of the refrigerator and the
wall behind it.
G
K
L
INSTALLING THE REFRIGERATOR
Make sure the floor is solid and level.
The refrigerator must be installed in a substantial enclosure
and level.
NOTE! Do not install the appliance directly on carpeting.
Carpeting must be removed or protected by a metal or wood
panel beneath the appliance, which extends at least full
width and depth of the appliance.
All areas within the recess have to be sealed. Verify that
there is a complete seal between the front frame of the
refrigerator and the top, sides and bottom of the enclosure.
A length of sealing strip is applied to the rear surface of the
front frame for this purpose. The sealing should provide a
provide a complete isolation of the appliance's combustion
system from the vehicle interior.
INSTALLATION INSTRUCTIONS
K
M
NOTE! Be careful
not to damage the
sealing strip when
the refrigerator is put
in place.
SECURING THE REFRIGERATOR
It is important to follow the sequence in securing refrigerator in
enclosure since failure in doing that can cause leakage between
the frame and cabinet!
Plastic caps are provided to cover the screw holes in the top
decoration.
Any space between the counter, storage area or ceiling and top
of the refrigerator greater den 1½ inches should be blocked.
The heat produced at the rear of the refrigerator will become
trapped in this space, making the top of the refrigerator hot and
reduce the efficiency of the refrigerator.
After the refrigerator has been installed (ensuring a combustion
seal at the front frame), the refrigerator is to be secured in the
enclosure with six screws (not included).
Install the six screws in the following order:
1.
Two screws installed through the front base.
2.
Two screws installed in the top frame.
3.
Two screws installed in the rear base.
3 rd.
The refrigerator is provided with a lower front strip (shipped as
a loose part). The front strip is to be attached after the refrigera-
tor is set into the cutout opening.
- 6 -
2 nd.
1 st.
4 th.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rm2820

Table of Contents