Dometic RM2620 Installation And Operating Instructions Manual page 10

REVERSING THE DOOR SWING
The refrigerator is equipped with hinges that makes it possible
to change the direction the door opens by moving the hinges to
the opposite side.
To change the door hinges from one side to the other, follow
these steps:
1. Open the top door and remove the two screws hold-
ing the top decoration. The screws are accessible
from beneath.
2. Remove the top hinge pin and lift out the top door.
3. Remove center hinge pin and lift out the lower door.
4. Unscrew the bottom hinge pin.
5. Remove the plastic cap from the opposite lower
hinge and place it in the hole just "left empty" by the
lower hinge pin.
6. Screw the lower hinge pin in the hole from which the
plastic cap was removed.
7. Before replacing the doors on the refrigerator, re-
move the catches and move them to the opposite side
of the cabinet. The holes are covered with plastic
caps that must be removed and inserted in the holes
that previously held the catches.
8. Unscrew the handles and move them to the opposite
side of the door.
9. Insert the plastic caps into the holes left open on the
doors. (Plastic caps for empty holes are in the parts
bag inside the refrigerator.)
10. Remount the doors and hinge pins in the reverse
order of their removal.
11. Before the top decoration is refitted, check that the
door closes easily and the gasket seals well on all
sides.
MOUNTING INSTRUCTIONS
- 10 -