Siemens SIPROTEC 7SD600 System Manual page 108

Numerical line differential protection SIPROTEC 7SD600 V3.0
0 1 . 0 1 . 9 9
A
0 1 : 1 5 : 0 6
D A T E
A
2 7 . 1 0 . 9 9
T I M E
A
1 3 : 4 4 : 2 7
Siemens AG January 1999
Operating instructions
System manual
[8101]
First the "current" date (DD. MM.YY) and the curernt
B
time (HH:MM:SS)are displayed. The actual setting
blocks may be reached with B.
[8102]
A new date can now be entered. This is done in the
order: day, month, year DD " MM " YY
Starting at the default value the day is increased to
the current date by pressing the "+" key. The " key
is pressed to reach the month. By pressing the "+"
key, the month is increased until the current month is
reached. Then the year is selected with the " key,
and increased with the "+" key until the current year
is reached. The values can be decreased with "-".
Finally the whole date input is confirmed by pressing
the Enter key E.
[8103]
To switch from the date setting to the time setting, B
is pressed. A new time can now be entered. This is
done in the order: hours, minutes: HH " MM
Starting from the default value first the hour is increa
sed to the current hour by pressing the "+" key. Then
change to the minutes by pressing the " key and
increase the minute to the current value with "+".
The values can be decreased with "-".
There is no need to set the seconds. The seconds are
automatically set to zero when the time input is con
firmed.
The complete time input is confirmed and becomes
active on pressing the Enter key E.
6
Order no. E50417-G1176-C069-A1
6 - 27